Support product software and utilities

Software

Designed for Windows XP, Windows Vista Capable

GlobeTrotter® Connect 3.1 (GIx505)

3.1d0-1086P

Connection software for Windows 2000, XP and Vista

Mac OS

GlobeTrotter® Connect for Mac 3.1

3.1.19_P0162

Driver installer

Designed for Windows XP, Windows Vista Capable

Driver package 5.0.33.0	5.0.33.0	Windows 7 Legacy Mode certified drivers. Note: For use in 5.0.x.x driver upgrade only (e.g. GlobeTrotter Connect). Driver is used in Legacy Mode only. Mobile Broadband features is not supported
Driver installer package 5.1.36.0	5.1.36.0	This driver installer can only be used in Windows 7 Mobile Broadband mode. After installation, connection of the Option device can be made through Windows Mobile Broadband instead of using Option connection managers. Important note: This driver CANNOT be installed on any other Microsoft OS than on the Windows 7. If you already have installed the GlobeTrotter Connect, this driver package CANNOT be installed on top. This will create a driver conflict.

Mac OS

MAC Driver 3.31.0

3.31.0

Driver with support for Mac OS X 10.6 aka Snow Leopard (32-bit and 64-bit). Fixed hang while trying to wake up from selective suspend. Fixed issue where driver would hang at resume when the device had been removed during sleep. Fixes pop-up "New Network interfaces" when drivers are already installed

Updater

Designed for Windows XP, Windows Vista Capable

iCON®505 SmartFire: CAT. 10 firmware & uCANConnect software upgrade

This commercial upgrader will update your device to FW 3.19.0, which is CAT.10 ready (14.4Mbps) and will upgrade the software to uCANConnect 2.2.3.230 Windows Only Note: the following flasher can not be used with devices purchased through a network operator. Please contact the network operator directly for assistance. Please be advised to remove the GTConnect software first before you install the uCANConnect from the device.

Mac OS

iCON®505 SmartFire: CAT. 10 firmware upgrade

v1.0.0.236

This commercial upgrader will update your device to FW 3.16.0, which is CAT.10 ready (14.4Mbps) MAC only Note: the following flasher can not be used with devices purchased through a network operator. Please contact the network operator directly for assistance.